A highly efficient damping glue for plywood, particle boards and plaster
boards in floors and walls.
Noisekiller Yellow is a unique highly efficient visco-elastic damping glue developed for
acoustical improvement of floors and walls where there are high demands for sound
NoiseKiller Yellow is a non-toxic damping glue
suitable for gluing together plywood, particle and
plaster boards. The loss factor of NoiseKiller Yellow
is very high and it is possible to improve the impact
noise reduction (“Ln) with up to 16 dB by gluing
floorboards together with Noisekiller Yellow
according to the sandwich principle.
Noisekiller Yellow must not be confused with
common construction glues since these generally
has a very low or no loss factor at all when
compared to a visco-elastic material.
Areas of Application
NoiseKiller Yellow is suitable for
• Impact noise reduction in new installations and
rebuildings of noise sensitive buildings.
• Damping of recording studio floors and stage
• Sound improvement of doors.
• Floors in heavy vehicles such as busses and
Apply NoiseKiller Yellow on a clean, dry surface.
The glue should be applied with a thickness of
approximately 1 mm (1 liter per m2) between two
plaster-, plywood- or particle boards.
The glue can be applied with conventional methods
using a serrated spatula or similar. Larger areas
can be applied using a spray gun.
The boards are pressed together when the glue is
still wet with a pressure of approx. 0,5 kg/cm2.
When floors are glued the boards can be sparsely
screwed. After the glue has dried the screws are
After complete installation the top surface can be
used as an untreated surface when it comes to
cutting or milling. The sandwich board has a lower
bending stiffness than a homogenous board of the
same thickness. To keep the same stiffness the
thickness of the board has to be increased by 50%.
NoiseKiller Yellow dries in two stages. First the
water vaporates (1-3 hours) and then the glue
hardens. After ca 24 hours the glue will have
achieved the full damping effect.
Odour: Odourless after drying
Density: 1030 kg/m3
Viscosity: 400+ 100 mPas
Flash point: Non flammable
Installation temperature: 0 – +40° C
Film thickness: 1-3 mm (applied in several
Shelf life: At least 6 months in unopened
Drying time: 4-6 hours